Files
Acknowledgements
Open Educational Resources (OERs) were created for the East Tennessee State University course ENTC 2170: Engineering Graphics. TN Open Education Grant Project – Cycle 3 (“OER Grant”) funded the creation of these OERs.
Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.
© East Tennessee State University
Recommended Citation
Craig, Leendert. 2022. Module 10: Introduction to Fusion 360 Part II. ENTC 2170: Computer Aided Design and Drafting.
https://dc.etsu.edu/entc-2170-oer/11